Anyang City, Dazheng steel plate warehouse: steel plate warehouse out of the material is not a problem

Dazheng steel plate warehouse in Anyang city: firstly, the downstream equipment such as rotor scale at the bottom of the warehouse will be knocked to the maintenance position. The lighting fixtures in the warehouse are entered from the material level meter entry hole in the middle of the top of the warehouse. When entering the warehouse to clean up, the ratio of the number of people outside the warehouse to the number of people inside the warehouse should be greater than 2:1, and the outside should be assigned to monitor. From the top of the library door to observe the library pile of materials and the library ladder solid situation and the top of the library, after confirming the safety, before entering. When the personnel enter the library, they should tie two safety ropes, one fixed on the dust collector bracket outside the library, and one fixed on the ladder inside the library.

 

Begin to clear the library, look at the flow situation, feed the mill; if the flow is too small, in the upper pipe of the rotor scale to install the pipeline to release the ash, put down the fly ash and mixed material slag mix to do mixing material. First at the bottom of the library with iron rod, compressed air to poke material; then at the top of the library with compressed air for blowing and pounding; into the library first compressed air blowing, long stick poke material, and finally available shovels, picks and so on. During the construction period, the construction personnel must wear good safety clothing, do not touch the lighting fixtures, lines, poke the material, people from the material must be far away, to prevent trashing material to bring danger.